patch-2.0.31 linux/Documentation/isdn/README.audio

Next file: linux/Documentation/isdn/README.avmb1
Previous file: linux/Documentation/isdn/README.HiSax
Back to the patch index
Back to the overall index

diff -u --recursive --new-file v2.0.30/linux/Documentation/isdn/README.audio linux/Documentation/isdn/README.audio
@@ -1,4 +1,4 @@
-$Id: README.audio,v 1.3 1996/06/05 02:19:36 fritz Exp $
+$Id: README.audio,v 1.5 1997/02/23 23:53:46 fritz Exp $
 
 ISDN subsystem for Linux.
   Description of audio mode.
@@ -12,7 +12,7 @@
 
         AT+FCLASS=8      Enable audio mode.
                          This affects the following registers:
-                           S18: Bits 0 and 3 are set.
+                           S18: Bits 0 and 2 are set.
                            S16: Set to 48 and any further change to
                                 larger values is blocked.
         AT+FCLASS=0      Disable audio mode.
@@ -86,8 +86,11 @@
     starts sending audio data to the application. There are several
     escape sequences defined, all using DLE (0x10) as Escape char:
 
-    <DLE><ETX>              End of audio data. Emulator stops
+    <DLE><ETX>              End of audio data. (i.e. caused by a
+                            hangup of the remote side) Emulator stops
                             recording, responding with VCON.
+	<DLE><DC4>				Abort recording, (send by appl.) Emulator
+							stops recording, sends DLE,ETX.
     <DLE><DLE>              Escape sequence for DLE in data stream.
     <DLE>0                  Touchtone "0" received.
          ...
@@ -107,13 +110,16 @@
     <DLE>s                  silence. Silence detected from the
                             start of recording.
 
-    Any character sent by the application, except XON (0x11) or XOFF (0x13)
-    immediately stops recording.
-
   Audio playback.
 
     When sending audio data, upon AT+VTX command, emulator responds with
     CONNECT, and starts transferring data from application to the phone line.
     The same DLE sequences apply to this mode.
 
+  Full-Duplex-Audio:
+
+    When _both_ commands for recording and playback are given in _one_
+    AT-command-line (i.e.: "AT+VTX+VRX"), full-duplex-mode is selected.
+	In this mode, the only way to stop recording is sending <DLE><DC4>
+    and the only way to stop playback is to send <DLE><ETX>.
 

FUNET's LINUX-ADM group, linux-adm@nic.funet.fi
TCL-scripts by Sam Shen, slshen@lbl.gov